Student Work
HOLE BORING DEVICE FOR THE MANUFACTURE OF A BAMBOO BICYCLE FRAME
PublicDownloadable Content
open in viewerThe objective was to design a device to create an appropriately sized bore in a bamboo shaft so that it may accept a seat post for use in a bicycle frame. This device was created to facilitate manufacturing of low cost bicycle frames for use in a third world economy. Axiomatic design was used to translate design needs into a self-centering vice and linear guide system that can accommodate the large tolerances associated with bamboo.
- This report represents the work of one or more WPI undergraduate students submitted to the faculty as evidence of completion of a degree requirement. WPI routinely publishes these reports on its website without editorial or peer review.
- Creator
- Publisher
- Identifier
- E-project-042711-114234
- Advisor
- Year
- 2011
- Date created
- 2011-04-27
- Resource type
- Major
- Rights statement
Relations
- In Collection:
Items
Permanent link to this page: https://digital.wpi.edu/show/hh63sx24q